Ultraviolet Flame Sensor - XSKH047
Our ultraviolet flame sensor could detect the wavelength of the flame in order to prevent early fire disaster.

Xspark flame sensor is a high performance sensor that gives notice if flame or particular wavelength spectrum (185nm~260nm) and flicker above threshold is detected. By detecting early causes of fire, it provides safety and security to your assets and life.
Ultraviolet flame detection
Detector range : from 5m (with 2 cm flame size) to max. 74m (with 1m flame size)
Detector angle : horizontal 90 degree and vertical 90 degree
Response time : 1~16 seconds (configurable depending on the place)
Our ultraviolet flame sensor (XSKH047) provides high-quality performance in detecting early fire disaster. It could detect small flame and give notification/alarm if it is dangerous. The flame sensor is dust and water resistant (IP64), which allows it to be installed in harsh environment.
Xspark flame sensor is a high performance sensor that gives notice if flame or particular wavelength spectrum (185nm~260nm) and flicker above threshold is detected. This kind of spectrum (ultraviolet) is usually produced by burned material that goes through an oxidation process, followed by thermal radiation. It has a short wavelength and is not visible with bare eyes.
Detection of 185nm~260nm UV wavelength
Detection Angle
Flame sensor XSKH047 detects the flame (spark) with the angles within horizontal 90 degree and vertical 90 degree.
Detection Range
Our sensor is highly sensitive and could give response in 1~16 seconds (based on user configuration) after detecting a potential fire disaster (blaze, flame, spark, etc.)
Product Architecture

Wiring System
The sensor is connected to four 0.2mm2 cables (red, black, white, and green) with the length of 50cm each. The details are given as follows:
Make sure to connect the cable (+,-) correctly as wrong connection might damage the UV sensor.
Please glue the handler and sensor with strong adhesive to make it water resistant.
Specification
MODEL Ultraviolet Flame Sensor - XSKH047
Wavelength Detection Range 185nm ~ 260nm
Power DC 7~24V, Idle mode: 0.01A, Detecting mode: 0.03A
Size Diameter 68mm, width 25mm, weight 75g
Detection Range From 5m(with the flame size of 2cm) to max. 74m(with the flame size of 1m)
Detection Angle Horizontal 90, Vertical 90
Material ABS RESIN
Dust/Water Resistance IP 64
Response Time 1s, 2s, 4s, 8s, 16s (Configurable)
Tamper Could also be used to stop non-fire disasters such as damage, prank, error, burglary, etc.
System Info Contact